Tuggers ::

Moto-Tugger Electric Tug

Request Tugger Quote


When it comes to pulling single or multiple carts, the Moto-Tugger provides an easy to operate solution.

This highly maneuverable and easy to use tugger features solid state variable speed control, regenerative and automatic braking. The Moto-Tugger is equipped with an onboard battery and charger pack.

This tugger can pull up to 1,500 lbs. and has several easy to install tugger-to-cart and cart-to-cart hitch arrangements. The Moto-Tugger also features a Quick Hitch Lift System that can hook up and disengage in a matter of seconds by a push of a button.

Request Tugger Quote

Ergonomic Handle

Ergonomic Handle

With infinitely variable speed operation for tight turning in close quarters, safety reversing switch and horn.

Quick Hitch System

Quick Hitching

Quickly hitch onto a wide variety of non-powered carts to electrically pull them and reduce operator strain.

Single Cart Tugger

Single Carts

The Moto-Tugger can tug large, heavy single carts.

Tugging Multiple Carts

Multiple Carts

Daisy chain multiple carts together to pull smaller, lighter carts.


MC-TG-11,500 lbs24"W x 18.7"L X 41.6"H8.75"ø(2) 12v 22AHr120 lbsQuote
Max Capacity1,500 lbs
Size24"W x 18.7"L x 41.6"H
Speed0 - 3 MPH
Batteries(2) 12v 22AHr
Weight120 lbs
Quote FormQuote

Standard Features

  • 24-Volt DC Transaxle Drive
  • 24-Volt DC Lift Motor/Actuator
  • Non-Marking, Flat-Free Tires
  • 22 Amp/Hr AGM Batteries
  • Quick-change battery system
  • Self-diagnostics Controller
  • Horn and Key Switch
  • Lift button and Throttle
  • High/Low Speed Switch
  • Small footprint
  • Built-in battery with BDI
  • ABS shroud
  • Travel wheel
  • "Rain Proof" (IP-54 rating)
  • Quick Hitch System
  • Numerous Hitches Available


Cart Hitch For Long Carts


Cart Hitch For Large Caster Carts


Cart Hitch For Tugging Multiple Carts


Cart Hitch For Moto-Cart


There are various hitches that can be welded or clamped to existing carts.

The slide clamp tubes fit underneath the cart to provide receiver tubes at both ends of the cart. Model 4752 is for carts 40" - 55" long. Model 4753 is for carts 56" - 76" long. Custom tubes are also available.

The Male Hitch end slides into the receive tube and has a safety latch for towing. Model 4750 is for carts with 5" or 6" casters and Model 4755 is for carts with 6" or 8" casters.

Model 4754 is used between carts when pulling multiple carts.

Model 4756 is designed to fit our standard Moto-Cart, Models MC-10S, MC-10M and MC-10L, allowing the Moto-Cart to become a tugger as well as a platform cart. (Must order hitch 4755 to tow carts with The Moto-Cart)